mower deck motors, bearings, was: Re: (ET) Weeder / Cultivator

["MR23 \(Christopher M. Meier, Mpls, MN\)" <mr23 mn rr com>]

I spoke with Bill Gunn last week, during our conversation (about mower
deck motors) he mentioned that the units are designed to have their
bearings replaced every 10 years.  This 'mentality' may explain why
the cultivator bearings may not be able to be externally lubed.

Has anyone also had bent mower deck motor shafts?  Have you
lived with them, or had the motor units rebuilt or replaced?  Since
my last discussion with Bill about bearings, I've checked my motors
and found they all 3 have bent shafts.  I need to get on the horn to
him again, and find out how much he wants for rebuilt motors, and
decide if I'm just going to re-bearing the one motor that has a stiff
and noisy bearing, or if I'll trade one or all 3 in for rebuilt units...

-Chris

----- Original Message ----- 
From: "Pestka, Dennis J" <Dennis Pestka mkg com>
To: "'Elec-Trak Email Discussion List'" <elec-trak cosmos phy tufts edu>
Sent: Wednesday, June 13, 2001 12:52 PM
Subject: (ET) Weeder / Cultivator


> Looking for some advice on the Weeder / Cultivator attachment.
> My runs but it seems fairly slow.
> Talked with a electric motor shop and he was surprised it didn't have a
> place to oil the top sleeve bearing.
> He also suggested checking the gear box for dried up oil/grease.
> 
> Does anyone have any experience fooling with these.
> Is there a maintenance manual available ? maybe Bill Gunn.
> Does anyone know what type of oil/gear lube that goes in the gear case.
> 
> Any help would be appreciated.
> Dennis