[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: (ET) mower arms information (revised again)



Title: Re: (ET) mower arms information
After more careful examination (the punch & hammer variety), I found that the smallest hole was, in fact, the center of a neatly sheared roll pin. After punching it out, I now have 3 arms that use a 1/8" x 1" roll pin.  Many thanks to Dean for suggesting this possibility.  I would have stared at it for hours without getting it.  Now I've got to run to Home Depot for a supply of pins....
 
 
Pieter
-----Original Message-----
From: Pieter Litchfield [mailto:plitch attglobal net]
Sent: Friday, April 07, 2000 08:55 AM
To: ET discussion list; Dean A. Stuckmann
Subject: RE: (ET) mower arms information

Dean - you may be right - here's what I've found after disassembly and degreasing:
 
Monty's drawing (wheelhorse?) - calls for a 1/4" x 15/16" roll pin on printed parts list
Two arms in my collection have a 1/8" x 1" roll pin - I've removed them to check dimensions
another has a 1/16" hole (no pin) - could be a broken pin as you suggest
 
I will examine them all very closely for broken pins, but I also think that its entirely possible GE went to bugger pins as time went on due to breakage.  Industrial archeology, ain't it great?
 
-----Original Message-----
From: owner-elec-trak cosmos5 phy tufts edu [mailto:owner-elec-trak cosmos5 phy tufts edu]On Behalf Of Dean A. Stuckmann
Sent: Thursday, April 06, 2000 08:39 PM
To: ET discussion list
Subject: Re: (ET) mower arms information

Hi,
It isn't impossible, but seems unlikely.  I'm taking for granted that the arms that you saw with the small hole was disassembled.  The small hole may be because the roll pin may still be in the bar with the ends sheared off. When one of the arms came apart on my deck some 17 or so years ago, I could not easily see what held it together with the grease and dirt on the shaft.  Only after close examination did I discover that the ends sheared from the pin and I had to drive it out for a new one.
Dean

From: "Pieter Litchfield" <plitch attglobal net>
Date: Thu, 6 Apr 2000 20:58:28 -0400
To: "ET discussion list" <elec-trak cosmos5 phy tufts edu>
Subject: (ET) mower arms information


Monty McGraw was kind enough to post a picture and parts list to answer my question about how to assemble a front mounted mower arm.  It's clear from the diagram and parts list that there is indeed a 1/4" x 15/16" roll pin pressed through the shaft to retain it in the outer cylinder.  Today I met with another list member to find some parts, and in examining a few arms in his collection and mine, we find the hole through the shaft (in the position indicated in the diagram) was no where near 1/4".  In fact it appeared to be about big enough for a slim cotter pin.  So apparently there was an "early version" which had a much smaller pin, and a later version which had the 1/4" pin.  I am sure I'll be able to figure out how to deal with my arms (drill the hole larger!), but just thought I'd share this bit of trivia with the group.


Pieter Litchfield
new e-mail is: plitch attglobal net