[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) Plows suck for snow (dead blower)



On 1/25/26 18:51, wavetech optonline net wrote:
The key to the snow thrower is to keep the shoot slick as you can, I used wax.
POR15 on the chute throat. Takes years to wear away and is has hard and smooth as glass.

And keep feeding it with snow not enough snow and it will freeze up.
Oh yes, there are times when you have to go into second gear to keep the auger going. I was running in LL but at speed 8 to keep the snow up when it broke.

However I'm screwed. Went out tonight and tried to move snow. Even worse than this afternoon; the blade just glides over it and does nothing. I've got the kids shoveling out the car at the top of the driveway; will go to the hardware store tomorrow get chain and fix the blower.

Chain is rusty, 50 years old, and yeah should have been replaced. Springtime I'm taking the whole thing apart; replacing the bearings and whatnot.




On 1/25/2026 6:39 PM, David Roden wrote:
Back in the late 1990s and early 2000s, I had a rusty old blade and a
craggy old but working snow thrower for my E15.  Tried the snow thrower
once with somewhat wet snow.  It clogged almost immediately.

Cleared it.  Threw a little snow and it clogged again.  Rinse, repeat.

By and by, though I, this is for de boids.  I may have thought it a little
bluer than that, actually.  At any rate, I took the beastly blower off,
wrestled it into the garage, and put on the dozer blade.

That worked better.

Once I got tire chains, it was MUCH better.

For the rest of the E15's life with me, I cleared our driveway with the
blade.  It always did a fine job.  I left the snow thrower right where I'd
parked it that snowy day.  Never missed it once. About 15-20 years on, I
gave it away to a good home.

That's how blade vs snow thrower went for me.  As with just about
everything, though, your mileage may vary.


David Roden - 25 Years with ETs

= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Note: mail sent to the "etpost" address will not reach me.  To send
me a private message, please use the address shown at the bottom
of this page : http://www.evdl.org/help/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =




_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak