Re: (ET) E15 resistor board connections

[Chris Zach <cz alembic crystel com>]

It had a big long edge clamp that would come loose, break, etc due to 
the lack of support. Better to solder, you could also replace it with a 
molex plug so you can remove the board in the future.

C

On 8/10/2021 6:06 PM, Jay Donnaway via Elec-trak wrote:
> Was the E15 Resistor Board originally soldered to the harness, or used 
> some sort of edge clamps?  I'm replacing mine, and the old one has 
> soldered leads without a whole lot of slack, so it is tempting to build 
> a pigtail with a multipin connector for a quick swap option.
>
> Thanks,
> Jay
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak