[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) First parts to go NLA--Motor spacers



McMaster-Carr has a wide selection of high temp insulating materials, in various sizes and shapes. Something could be machined from an appropriate material.

Dave


On 9/21/2020 10:26 PM, Chris Zach via Elec-trak wrote:
This isn't good. The two square spacers on my E15 motor have crumbled and harold has not been able to source replacements. I figured this time would eventually come and it's time to start figuring out replacements.

First thought I tried was rubber hose and electrical tape. Seems like a good idea but the first time the motor loads up the heat will melt the rubber/plastic and make a mess. Need a high temp solution.

Anyone got any other ideas? Personally I may try making a mold and building a pair of cubes of JB Weld, then drilling the centers. JB can handle muffler temperatures (500f) so it should be able to handle a motor. Any other ideas?

C

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak