[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ET) Alltrax, key switch, and charge/run switch
I have mine set up to shut down the controller with the key off. I think
that's what the diagram I got with the controller showed. I don't think
the
list allows attachments, but I'll send you a copy of the schematic in a
separate message.
I don't use the antirolling feature much. That's what the brake is for.
I
don't much like the idea of current going into a stopped motor, nor am I
keen on the use of battery energy for this purpose.
I don't know what the max voltage is, but Steve suggested that the
on-charge
peak voltage of a standard ET charger would (or at least might) be too
high.
I cheated and just told myself I'd remember to open the main disconnect
before charging. In practice, over the years, I've accidentally left the
disco closed maybe twice. No harm resulted either time However, I use
gel
batteries and charge to a lower voltage than most here (just under 43v).
David Roden - Akron, Ohio, USA
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Note: mail sent to the "etpost" address will not reach me. To send
me a private message, please use the address shown at the bottom
of this page : http://www.evdl.org/help/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =