Sorry, it's an E12, and yes, it should be S3, not S2. I
understand that wire 30 has to be connected, but the loud humming noise
seems unusually loud. When I first got the tractor, one of the diodes
was blown and when I tried to charge, the charger made this same loud
noise. So, there's the normal noise (a sort of soft hum) of the
charger when it's not connected to the battery pack, and then there'
this very loud noise (more of a loud buzz) when the charger is
connected to the battery pack. It never used to be this loud.
Some background. I mowed the lawn for the first time a couple of
weeks ago, and I think I was mowing in the wrong gear, since the power
use guage was often in the red. Things seemed a bit hot when I plugged
in the charger. When I left the garage, the charger was humming as
usual. A few hours later when I returned to the garage, I found it had
tripped the house breaker. When I reset the breaker and started the
charger again, I got this loud buzz instead of the soft hum. When I
removed the charger, I found that the capacitor top had bulged upward,
rather than being flat. I suspected that was now trash, and replaced
it with a brand new one. When I hooked it all back up again and tried
to charge, the charger continued to make this loud buzzing noise
instead of the soft hum it usually makes.
----- Original Message -----
From: "RJ Kanary" <rjkanary nauticom net>
To: "paul mitchell2007" <paul mitchell2007 comcast net>
Cc: "Elec-trak tufts" <elec-trak cosmos phy tufts edu>
Sent: Monday, May 11, 2009 10:32:31 AM GMT -05:00 US/Canada Eastern
Subject: Re: (ET) charger problem
I'm confused.{ But then it IS Monday morning, and I've had
but one cup of coffee.} What flavor of ET are we working on? The first
charger diagram I pulled up (since I'm just guessing. <G>) shows
an S1 and an S3 but no S2.
Wire 30 goes to CB-2.It HAS to be there, or the charger's
output is not directed to the battery pack. The loud humming noise you
hear when it's connected could well be the sound of the charger doing
exactly what it's supposed to be doing. Charging. :)
What conditions existed previously to start this investigation?
Fetching that much needed second cup of Joe........
RJ
paul mitchell2007 comcast net
wrote:
Hi,
My charger hums quietly when plugged in and the #30 wire from
the circuit breaker is not attached to S2 on the charger, but when
attached to S2, makes a very loud humming noise. The capacitor is
brand new and I a local alternator shop that rebuilt all my tractor
motors told me that the diodes are fine (they recently replaced them).
The resistance from each diode to the heat plate measures zero. Any
ideas? Do I need a new heat plate? If so, where do I get one?
Thanks!
Paul
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak