[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: (ET) Small mower motor overhaul



It should come out REAL EASY.  Find a round bar as close to the hole diameter as you can and tap lightly.  This is an indication
of a worn armature shaft, so use locktite when you put it back together.
 
Larry Elie
 
-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu [mailto:elec-trak-bounces cosmos phy tufts edu]On Behalf Of KevinC927 aol com
Sent: Saturday, June 26, 2004 1:00 PM
To: elec-trak cosmos phy tufts edu
Subject: (ET) Small mower motor overhaul

My stepson and I are replacing the bearings in a set of these.  In one, the blade end bearing stayed in the motor housing after pushing the armature shaft out.  Any tried-and-true methods for getting this bearing out of there without damaging the housing?

Thanks in advance!

Kevin Carter
E15