Re: (ET) mower deck question

["daveb" <daveb seanet com>]

Rod where is that dumpster?!!!  You are in Portland Oregon right?  I may 
have 
have come down from seattle to do a little diving.  :^)

dave
seattle

--
Open WebMail Project (http://openwebmail.org)


---------- Original Message -----------
From: Rod Hower <rodhower ameritech net>
To: elec-trac <elec-trak cosmos phy tufts edu>
Sent: Mon, 29 Mar 2004 16:18:13 -0800 (PST)
Subject: (ET) mower deck question

> My mower deck appears to have a hollow metal bar
> welded to two metal blocks maintaining a 1" space
> between the deck and the wood rollers.  It appears
> as if this is 'aftermarket'.
> I looked at the 'main components' pdf from ET.org,
> but the quality is low.
> Does anybody have better pictures showing the back
> deck roller assembly?
> Hopefully Bill Gund has this part (that holds the
> rollers).
> 
> How much does bill charge for the 14" mower blades
> for an E15?
> I also need the part that attaches to the PMDC motor
> shaft.  I butchered the motors this weekend because
> everything was rusted so bad.
> I'm putting 3 BLDC motors with variable speed control
> in their place (these are dumpster dive motors,
> otherwise sold for $300 each, and they are new)
> Rod
> 
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
------- End of Original Message -------