RE: (ET) Mower deck motor

["Rod Hower" <Rod Hower ametek com>]

I've been selling some 18Vdc motors on Ebay that would work fine at 36Vdc.
I haven't tried it on my E-15 yet, but after taking one of the motors off
the deck
last night in the snow, I probably will.
I broke 3 of the bolts holding the motor to the deck.
I had to grind off the blade.
Now I have to figure out how to pull the piece off the motor shaft
that holds the blade.  Is that piece pressed on?
I measured no load current at 20Vdc, it was 1.5Amps.
I'm going to replace the bearings to see how much this
current drops.
Rod



                                                                           
                                          
                      "T Humphrey"                                         
                                          
                      <thumphrey mynra com>              To:       
<elec-trak cosmos phy tufts edu>                  
                      Sent by:                           cc:               
                                          
                      elec-trak-bounces cosmos ph        Subject:  RE: 
(ET) Mower deck motor                         
                      y.tufts.edu                                          
                                          
                                                                           
                                          
                                                                           
                                          
                      03/18/04 08:44 AM                                    
                                          
                      Please respond to thumphrey                          
                                          
                                                                           
                                          
                                                                           
                                          





Bill can fix it.

Rod, does Ametek have a suitable substitute?

Stay Charged!
Hump


>
>
>-----Original Message-----
>From: elec-trak-bounces cosmos phy tufts edu
>[mailto:elec-trak-bounces cosmos phy tufts edu] On Behalf Of Steve
>Richardson
>Sent: Wednesday, March 17, 2004 9:31 PM
>To: elec trak
>Subject: (ET) Mower deck motor
>
>
>Hello Everyone,
>
>Does anyone have a used mower motor that fits the 42 inch front
mower deck
>for the E-15?  I have one with a bent shaft...
>
>Thanks
>
>Steve
>scr echoweb net
>
>
>
>_______________________________________________
>Elec-trak mailing list
>Elec-trak cosmos phy tufts edu
>https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
>






_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak