[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: (ET) Mower deck



Steve and Larry;

The only problem I have run into is;
If I don't lower the strap sufficiently, the back end of the mower will 
lift
up when going over the top of a hill. 
Enough slack in the strap allows the side support arms to swivel and leave
the mower deck level to the ground.

Dennis


-----Original Message-----
From: SteveS [mailto:ssawtelle fcc net]
Sent: Thursday, June 13, 2002 11:32 AM
To: elec-trak cosmos phy tufts edu
Subject: Re: (ET) Mower deck


Ah, good point. I always run it down pretty far - that would probably help.
I figure it must be something as I haven't seen many posts on this problem,
but it's a real eye-opener when it happens!

 SteveS


----- Original Message -----
From: "Elie, Larry (L.D.)" <lelie ford com>
To: "'SteveS'" <ssawtelle fcc net>; <>
Sent: Thursday, June 13, 2002 11:52 AM
Subject: RE: (ET) Mower deck


> Try NOT lowering the lift belt more than about half an inch after the 
> deck
is on the ground.  If you catch something, the deck will have to pull the
lift belt before it swings up.
>
> Larry Elie
>
>
> -----Original Message-----
> From: SteveS [mailto:ssawtelle fcc net]
> Sent: Thursday, June 13, 2002 10:56 AM
> To: elec-trak cosmos phy tufts edu
> Subject: Re: (ET) Mower deck
>
>
> Interesting ideas.
>
> While we are on the subject, has anyone modified their decks so they 
> don't
> swing up when the rear of the deck catches something in reverse? I get
real
> skittish everytime I go in reverse while mowing.
>
> SteveS
> E12S
>
>
> ----- Original Message -----
> From: "Christopher Meier" <mr23 mn rr com>
> To: <>
> Sent: Thursday, June 13, 2002 10:11 AM
> Subject: Re: (ET) Mower deck
>
>
> >
> > Has anyone evaluated modifying these decks to 'conform' to the ground?
> > I've considered hinging it at two points, for 3 sections.  The idea is
to
> > avoid
> > scalping high spots, or leaving long grass in small depressions, or at
the
> > base
> > of hills that have a fairly sharp transition.  (Yes, my lawn has many 
> > of
> > these
> > features!).  Just a thought so far...
> >
> > I've also considered putting a spring below the mower deck on the front
> > castor spindles to smooth out the deck movement on bumpier ground,
> > and to reduce transmitted forces to the deck and castor mount.
> >
> > -Chris
> >
> >
>