Re: (ET) just purchased e12

["MR23 \(Christopher M. Meier, Mpls, MN\)" <mr23 mn rr com>]

If you know the customer number that the previous owner used with
Bill, give him that too.  I made the mistake of not doing so the first
time, now I have a separate account, with no history, making his
job harder to look up the history.

Chris

----- Original Message -----
From: "Don Barry" <Don Barry kmtc com>
To: <elec-trak cosmos phy tufts edu>
Sent: Tuesday, April 24, 2001 7:11 AM
Subject: Re: (ET) just purchased e12


> Mark,
>
> Bill Gunn has the manual and a nice updated replacement power disconnect.
>
> Before you call Bill, make sure you have the SERIAL NUMBER of your e12
with you. Bill uses that info to set up your account, plus it gives him 
some
knowledge as to what revision your e12 is.
>
> Don
>
> Don Barry
> Infrastructure Manager, IT
> Kirby Corporation
> E-Mail: don barry kmtc com
> Phone: 713-435-1032
> Fax: 713-435-1070
>
> >>> mark blackburn <blckbrn6 yahoo com> 04/23/01 06:37PM >>>
> hi, i just purchased a e12 for 50$, its been in the
> outdoors for awhile so it needs some tlc. the power
> disconnect seems to be faulty (wont hold in position)
> but i dont know what is normal for this tractor. I
> NEED a wiring schematic for a e12. i already know that
> the deck hoist motor and or assy is froze as well as
> the brake pedal assy. the charger kicked the breaker
> after 5 mins or so . while it was charging the battery
> indicatorjumped all over the place. i got voltage
> reading of 12 vdc at drive motorand 26 vdc at
> solenoids for speed controls ( i think ) any help on
> where to start on this tractor would be a great help.
> thanks  Mark Blackburn
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
>