RE: (ET) Some Advise please

["Elie, Larry (L.D.)" <lelie ford com>]

Speaking of 'getting the screws out'... I'd like a few words with whoever
designed 
the hold-down on the electrolytic cap on the charger.  Even though there 
was
room, 
they used a strap with screws that are too big for a nut driver, and there
isn't space 
for an end-wrench.  You can either 'turn-down' a 11/32" socket (1/4" drive)
in a 
lathe, or remove the batteries and cut off the bracket.  When it goes back,
it will 
have smaller nuts.

Larry Elie


-----Original Message-----
From: Oasis654 aol com [mailto:Oasis654 aol com]
Sent: Thursday, July 13, 2000 10:27 AM
To: ThompsonG DFO-MPO GC CA; elec-trak cosmos5 phy tufts edu
Subject: Re: (ET) Some Advise please


hi geof, i think it can be disassembled the way you described.  i recently 
acquired several panels with selonoids etc that had been taken out that 
way.

getting the screws out of the panels may be the hardest part.  good luck,
jon 
k